Product successfully added to your shopping cart
Quantity:
Total:
There are 0 items in your cart. There is 1 item in your cart.
Total products:
Total shipping: To be determined
Total:
Quantity:
Total:
Total products:
Total shipping: To be determined
Total:
The Rotator Plate 90° is often used together with a PBS cube to combine two collimated beams at the same wavelength, allowing the power to be scaled without affecting the beam’s optical properties. A cost-effective alternative to a polarization half waveplate, this product rotates the axis of polarization by a half wave or ninety degrees in the range of...
Cylindrical Lenses 6X Magnification (AR 400-700 nm) are the optical system for reducing the divergence of the laser beam.
Single channel 1.5 A, 3.3-12 V laser diode driver. The low current version of the LPLDD-5A-12V dedicated to working with single and multi-mode laser diodes. Proper shunt resistor and customized parts assure low noise even with small current values. Analog input allows modulating the current with the speed of up to 100 kHz square waves.
This Mounted Triplet lens can be used to variably focus or collimate the laser light with reduced aberration due to its triplet (three element) design. Its relatively long effective focal length (EFL) of 8 mm allows it to focus laser light to a small spot.
455 nm Wave Rotator Plate 90° is a cost-effective alternative to a polarization half waveplate, this product rotates the axis of polarization by a half wave or ninety degrees in the range of 440 nm – 473 nm (blue light). It is often used together with a PBS cube to combine two collimated beams at the same wavelength, allowing the power to be scaled...
The single channel 5 A, 3-24 V laser diode driver with a built-in digital temperature controller. Analog input allows modulating the current which is proportional to the 0-5 V voltage given on the input. Temp controller circuits are powering whole logic part of the driver allowing to use an independent power supply to meet proper compliance voltage of the...
The TO-18 brass Laser Diode Housing Mount is the component used in laser systems.
The single channel 5 A, 3-24 V laser diode driver with digital temperature controller circuit and anodized heat sink. The proper size of the heat sink allows the driver to work well with up to 10 W power dissipated on a power transistor. The temperature controller is using a PID algorithm to maintain the set temperature. 10 A version of the driver is...
Reflectance > 99%, Transmittance >97%, 10 x 10 x 10 The high-quality polarization beam splitter designed for a red laser.
The Dichroic G-RB KVANT 10 x 20 is used for combining RED or BLUE with the GREEN laser light.
This is the power supply unit intended for PLH3D – series laser engraving heads.
