Product successfully added to your shopping cart
Quantity:
Total:
There are 0 items in your cart. There is 1 item in your cart.
Total products:
Total shipping: To be determined
Total:
Quantity:
Total:
Total products:
Total shipping: To be determined
Total:
This is the power supply unit intended for PLH3D – series laser engraving heads.
NDG7475 525 nm 1 W is the green laser diode - with a wavelength of 525 nm
The optical system for reducing the divergence of the laser beam. Dedicated for BLUE and GREEN beams which have better divergence than RED ones. Lenses have 2 X magnification and the divergence of the beam is also corrected 2 X times.
The single channel 5 A, 3-24 V laser diode driver with digital temperature controller circuit and anodized heat sink. The proper size of the heat sink allows the driver to work well with up to 10 W power dissipated on a power transistor. The temperature controller is using a PID algorithm to maintain the set temperature. 10 A version of the driver is...
The Dichroic G-RB KVANT 10 x 20 is used for combining RED or BLUE with the GREEN laser light.
Single channel 5 A 3.3-24 V laser diode driver with thermal protection. Based on many inquiries from customers, this version of the LPLDD-5A-24V driver is equipped with thermal protection which switches off the laser diode circuit if the temperature exceeds 45 degrees of Celsius. The thermal sensor is included. Additional LEDs signalize the current status...
The single channel 5 A, 3-24 V laser diode driver with a built-in digital temperature controller. Analog input allows modulating the current which is proportional to the 0-5 V voltage given on the input. Temp controller circuits are powering whole logic part of the driver allowing to use an independent power supply to meet proper compliance voltage of the...
Three channel version of the LPLDD-5A-12V driver. Changed capacitors allow this driver to work with compliance voltage levels up to 16 volts. Each channel is driven by independent 0-5 V voltage range analog input. An additional connector is added to make the connection more comfortable. Properly matched parts ensure low noise while used with lower...
Please add this feature to cart if you want to change the maximum current of the driver to 10 A. Works with LPLDD-5A-24V-PID and LPLDD-5A-24V-TP and their heat sink versions.
The Mirror HR RGB 10 x 20 is the high-reflect mirror with a special coating used for reflecting all colors. Efficiency >98%
The Dichroic R/G reflects a RED light > 99%, passes a GREEN light > 97%
