UCCNC software has a plugin that provide possibility of engraving any picture in a scale of gray, halftone or black and white.

  1. In the CONFIGURATION and GENERAL SETTINGS tabs, click on Configure plugins
  2. Find the plugin Laserengrave on the list. If it is your first time using this plugin, check the Enabled check and restart the software. Then reopen the program and click on Show button.

Laser Engraver Settings For UCCNC


  1. Now you can load image and, after set all of parameters, start engraving.

Image Settings at UCCNC for Laser Engraving