1. Connect one end of the PLH3D-CNC Adapter-to-Laser-Head Cable to the docking station on the LEAD PLH3D Mount. Secure this cable to the mount with a zip tie.

2. Further zip ties can be utilized to fasten the cable at the top of the Z-axis and then along the other side of the X-axis, as shown below:

 

3. Next, secure the cable along the X-axis drag chain using zip ties or by putting it through it.

4. For the next step, pass the cable around the X-axis motor and then secure the cable along the Y-axis drag chain in a similar fashion as in the previous step.

For the users who prefer to put the cable through the drag chain, bear in mind that you will have to remove one of the end connectors in the PLH3D-CNC Adapter to Laser Head Cable. Also, remember that the 5 wires’ connection is mirrored on the opposite side of the cable (and, thus, the order of the wires is flipped).

5. Next, connect the laser head cable to the output of the PLH3D-CNC Adapter.

6. Then, connect the LEAD Signal Cable to the output (TOOL HEAD) of the BlackBox controller.

The appropriate connection diagram between the PLH3D-CNC Adapter and the BlackBox Controller is as follows: 

7. Please follow it by connecting the BlackBox signal cable to the input of the PLH3D-CNC Adapter.

   8. Finally, plug the 19 V, 2.5 A desktop power supply into the socket on the PLH3D-CNC Adapter.