TEC-10A-24V Temperature Controller
TEC-10A-24V Temperature Controller is a simple TEC controller consisting of analog elements and a very small PCB board.
Select Additional Kit Components
Accessories
|
TEC Module 8 A
$19.00 |
Technical Data
Product Description
About the TEC-10A-24V Temperature Controller
TEC-10A-24V Temperature Controller is the simple TEC controller consisting of analog elements and the very small PCB board.
Compact size and big operating currents make it possible to use this driver in almost any project. Thanks to built-in MOSFET user doesn’t have to apply thermal compound and heat sink. Additional mountings holes, as well as wires connector, make assembly of the controller even easier. Temperature stabilization reaches +-0.4 degrees Celsius accuracy. High current, wide voltage range and high accuracy in a device of only 20 x 33 mm in size! The driver works in cooling mode and uses voltage feedback from an NTC thermistor. One 10k NTC B3950 thermistor is shipped with the temperature controller.
Thanks to a two-layer board and wide paths it is possible to use TECs with up to 20 A. Connectors allow to use a maximum current of 9 A so if there is a need to supply bigger Peltier cells, wires should be soldered directly into the driver's PCB board.
It is possible to join TECs parallel or in series. Please remember that high current needs proper wiring with bigger cross-section cables.
A maximum current flowing through the device depends on the TEC used. Voltage dropout on a driver is very small so current can be predicted by reading TEC labels. For example, 12704 means 12 V and 4 A. 12715 means 12 V and 15 A.